(1) The gas source work pressure is too low, should adjust the pressure valve suitably, enhances the work pressure.
(2) The glue gun is not clean, the glue cures the blockage passageway, at this time, must clear the dredging channel.
(3) The viscosity of the adhesive is not appropriate, if the stick through the big, resistance increased, the glue is not continuous or can not be made out of glue, therefore, to select the adhesive to meet the requirements.
Previous: How To Solve The Rubber Gun Leak
Related News
- Basic Information Of Glue Gun
- Product Advantages Of Hand-mixed Ru...
- Attention To The Use Of Plastic Guns
- How To Solve The Rubber Gun Leak
- Introduction Of Hot Melt Glue Gun P...
- Method Of Using Hot Melt Glue Gun
- Basic Definition Of Jumpers
- Application Of Hot Melt Adhesive Fi...
- Maintenance And Maintenance Of Hot ...
- Simple Classification Of Hot Melt G...
- How Does Glue Gun Solve Little Prob...